To adjust a hiking backpack, load it with a realistic weight, loosen every strap, then tighten from the bottom up: hip belt over the top of your hip bones, shoulder straps snug without overtightening, sternum strap, and finally the load lifters at the top of the shoulder straps. Your hips should carry most of the weight, while the shoulder straps keep the pack close to your back. All of it depends on the pack’s back length matching your torso, measured from the base of your neck to the top of your hips.
Contents
Load and loosen before you adjust a hiking backpack
Setting the hip belt on your iliac crest
Shoulder straps and the sternum strap
Load lifters and the angle that matters
Measuring your torso length
The first step to adjust a hiking backpack happens before you touch a strap. In its guide to measuring torso length, Gregory explains that pack sizing follows the length of your back whatever your height, so two hikers of the same height can need different sizes. Torso length runs from the C7 vertebra, the bony bump at the base of your neck when you tilt your head forward, down to the iliac crest, the top ridge of your hip bones.
Gregory’s method takes a minute with a soft tape measure. Put your hands on your hips, thumbs pointing back, and slide them up until they reach the top of the hip bone. Place the end of the tape on your C7 and let it hang down your back. Then slide one thumb sideways from your hip towards the middle of your lower back, and pinch the tape where it crosses that line. The number above your thumb is your torso length.
That number picks your size, and on an adjustable harness it tells you where to set it when you adjust a hiking backpack for the first time. Gregory’s adjustable packs come in S, M and L, and a size M, for example, fits torso lengths from 38.1 to 48.3 cm. The brand also says its sizes are the same whether a pack is sold as men’s, women’s or unisex. If you are still deciding on volume, our guide to hiking backpack capacity covers that choice before you get to fit.
On larger packs, the harness slides to match your measurement. The Deuter guide on how to adjust a backpack describes its VariQuick system, fitted to packs from about 35 litres: you find your back length, loosen and pull out the Velcro strip on the back panel, thread it through the four loops and fasten it. Smaller Deuter packs skip the adjustment and come in fixed back lengths instead, Regular, SL or EL. For loads above 10 kg, or on longer walks, Deuter calls the right back length critical to carrying comfort.
Load and loosen before you adjust a hiking backpack
An empty pack tells you very little about how it will carry. Deuter asks you to fill it to a realistic weight before you try it on, and Gregory recommends at least 4.5 to 9 kg inside. The easiest way to adjust a hiking backpack properly is to pack the gear you will actually take on your next trip.
Before you put it on, slacken every strap: hip belt, shoulder straps, load lifters and stabilizers. The sequence both brands describe then works from the bottom up, starting at the hips and finishing at the top of the shoulders.
More articles on WildSurvival
- Quinzhee Snow Shelter: How to Build One That Holds
- Stevenson Trail: Walking the GR70 With or Without a Donkey
- Microspikes: Choosing Winter Traction for Icy Trails
Setting the hip belt on your iliac crest
The hip belt comes first, and according to Deuter it should carry the main load. The brand tells you to centre the padded wings on the top of your hip bone. Set too high, the belt squeezes your waist; set too low, the wings rub against your thighs.
Gregory gives a slightly different marker. On its fit and sizing page, the brand puts the belt pad 2.5 cm above your iliac crest, and its measuring guide says the top edge of the hip belt should sit 2.5 cm above that crest. Both brands agree on the principle: the belt wraps the top of your pelvis, where the bone takes the weight.
Once it is in position, buckle the belt and pull it firmly tight on both sides. When you adjust a hiking backpack, this is the strap everything else builds on, since it is the one Deuter expects to bear the load.
Shoulder straps and the sternum strap
Next, to adjust a hiking backpack at the top, pull the shoulder straps down and back until they follow the shape of your shoulders. Deuter says to tighten them without overdoing it, because the hip belt should keep the main load. The brand also asks you to check that the shoulder strap anchor points sit between your shoulder blades.
Gregory adds a handy check for anyone trying to adjust a hiking backpack at the shoulders: the straps should rest fully on your shoulders and start wrapping onto your back about 8 cm below the top of your shoulders. If they start lower than that, the brand suggests trying a larger size. Harness designs vary from one maker to the next, and our Osprey, Deuter and Gregory hiking backpack comparison shows how each brand handles its straps and belt.
The sternum strap follows. Deuter sets it once the back length is right: clip it, then tighten it without restricting your breathing. Gregory places it across the chest at about heart height, where it holds the shoulder straps in position without pulling them out of shape or getting in the way of your breathing.
Load lifters and the angle that matters
The last step to adjust a hiking backpack is the load lifters, the straps linking the top of the shoulder straps to the frame of the pack. Gregory says they draw the weight towards your centre of gravity, for stability and energy savings, and let you shift weight from your upper body to your hips. Deuter asks you to tighten the stabilizer straps at the shoulders and on the hip belt wings to pull the load closer to your back.
The angle matters. Deuter says these stabilizer straps work best at an angle between 30° and 45°. On its trekking packs, you change that angle by moving a buckle higher or lower. On small packs it can be much flatter, even negative, and there Deuter uses it to fine-tune the back length, which shows how closely the two settings are tied together.
Shifting the weight as the terrain changes
You keep tweaking your straps once you are moving. Gregory describes two adjustments to make on the go. On flat ground or long stretches, loosen the shoulder straps a little and then tighten the load lifters, which moves weight off your shoulders and onto the hip belt, since your hips are better suited to heavy loads. On steep climbs, uneven ground or technical sections, do the reverse: loosen the load lifters, then tighten the shoulder straps, so a slightly higher centre of gravity gives you more control.
Deuter makes a similar point about how to adjust a hiking backpack over a long day. On long hikes, the brand suggests varying the split between hips and shoulders through the shoulder straps. Tighten the hip belt stabilizers for better load transfer, or loosen them for more freedom of movement. On bigger packs, slack straps let your back breathe on easy ground, while tight straps hold the load steady on rough terrain.
These tweaks happen as you walk, each time the gradient changes. It also pays to adjust a hiking backpack again at every break, especially after you take off or add a layer, because the volume and weight inside the pack have changed.
Where the heavy gear goes
How you fill the pack shapes how it carries, and it is worth sorting before you adjust a hiking backpack. In its guide on how to pack a backpack, Deuter sorts gear by weight. Your sleeping bag, down clothing and other light items go in the bottom compartment. Medium-weight items such as clothes go in the main compartment towards the outside. Heavier gear, the tent, food and thick insulation layers, goes in the main compartment at shoulder height and as close to your back as possible, so the heaviest part of the load sits near your body.
Deuter adapts that rule to the terrain. On easy trails, the heaviest part can ride high in the pack. In high mountains or when climbing, it moves lower, which means leaning slightly forward as you walk, and the brand recommends trekking poles for that. Small items go in the lid, weight is split evenly between the two sides, especially in the side pockets, and gear strapped to the outside is kept to a minimum to avoid wind, wet and snagging.
Deuter also puts a ceiling on total weight: we can carry a maximum of 20 to 25% of our own body weight. For a way to organize and compress your kit without buying anything special, our piece on the military packing technique for a backpack walks you through it.
Signs your pack is set up wrong
If you struggle to adjust a hiking backpack so it feels right, Deuter lists the symptoms of a back length that does not suit you. When it is too long, the shoulder strap attachments end up too close to your neck, the pads sit under your armpits and rub your neck and arms, and the pack tips backwards. When it is too short, the shoulder pads sit too low, dig into your skin and slide off your shoulders. The right length leaves your arms completely free and takes pressure off your neck.
Other signs come from the straps themselves. If your shoulders are carrying most of the weight, the hip belt has stopped doing the job Deuter gives it, so check its position on your hips and tighten it. A sternum strap that restricts your breathing falls outside both brands’ guidance, so loosen it or move it. Before blaming the pack, start again from the beginning and take the time to adjust a hiking backpack in the right order.
The table below gathers the reference points to adjust a hiking backpack:
| Part | Reference point | Source |
|---|---|---|
| Test load | At least 4.5 to 9 kg | Gregory |
| Torso length | From the C7 vertebra to the iliac crest | Gregory |
| Hip belt | Wings centred on the top of the hip bone, or pad 2.5 cm above the crest | Deuter, Gregory |
| Shoulder straps | Snug without overtightening, wrapping about 8 cm below the top of the shoulders | Deuter, Gregory |
| Sternum strap | Around heart height, breathing unrestricted | Gregory, Deuter |
| Load lifters | Angle of 30° to 45° | Deuter |
| Maximum weight | 20 to 25% of body weight | Deuter |
Keep these points handy the next time you adjust a hiking backpack before a trip, and measure your torso again whenever you switch to a new model.


